This item is limited to 10 per household.
── ahead bend to cut the work of the small part in the type of cutting edge
- Convenient precision nipper when cutting the parts of plastic assembly models from the gate
- By bending the tip of the cutting edge, corresponding to cut the work of more small part (bending angle of about 45 degrees)
- One side only to allow a smooth cut work in wearing a blade [single blade type]
- Stopper screw (set screw type) to reduce the excessive hit on both sides of the blade / blade set the stopper pin of prevention too open
- Cutting capacity
Gate part of the plastic assembly model (the middle portion of the runner and parts)
Plastic bars: diameter 2mm or less (recommended)
And convenient protection cap for the protection of (accessories) cutting edge
[please note]
- Is a common gate cut dedicated products of plastic assembly models.
- PS, PE, ABS, please use to cut the work of plastic parts that are displayed with the PP.
- Other hard plastic (transparent / translucent PS, polycarbonate, FRP, acrylic resin and the like), please do not use the cutting ability or more of the material of the product.
- Not suitable to cut the work of a non-plastic material. Please do not use.
( This is a machine translation. Please allow for possible misinterpretations in the text. )