This item is limited to 50 per household.
- Remarks: Bargain package specification of 3D-052 × 2
[JR Kiha 54 500 skirt skirt]
(1) Cut the part carefully from the runner using a nipper or cutter knife.
(2) After the base treatment and painting, attach it to the TN coupler as shown in the attached drawing.
- Mount in the hole of the base part of the TN coupler, fix it with instantaneous adhesive.
- Remove the jumper plugs on both sides of the trunk receivers.
- Adjust the air hose to the mounting hole after shaping and painting.
- Install the product's SNOWEROW. (If it is tough, cut both ends lightly.
※ Cut the attachment leg of the air hose with 1 mm length (not penetratable).
- Corresponding coupler: JC 0374
* Install one step before the normal position
- This product has been subjected to degreasing treatment at the time of inspection, please remove the oil and powder etc on the surface with a neutral detergent etc. at the time of painting, and then paint with the primer or the surfacer on the ground treatment .
- When bonding this product, instant adhesive is the best.
- Because this product is a material vulnerable to bending and impact on the properties of the material, please avoid bending and repeated detachment.
- Material: Acrylic (3D printer output)
( This is a machine translation. Please allow for possible misinterpretations in the text. )