This item is limited to 3 per household.
[Low-cost speed controller for small motors]
-MD-1 is an ESC (electric speed controller) dedicated to small motors.
-Compatible with brushed motors up to 370 sizes.
-It is small and lightweight and has a flat design so that it can be easily mounted on RC car kits and work sets, so it can be easily fixed with commercially available double-sided tape.
[Neutral brake specification suitable for operation of robots and work sets]
-MD-1 is available in two lineups: the same RC & ES for RC (RC car ESC specification), and suitable for robots and work sets (neutral brake specification).
-The neutral brake specification is easy to handle for robots and caterpillar work sets without rotating the motor by inertia.
-Unlike the general ESC setting, when the propo (transmitter) throttle (accelerator) is operated in the reverse direction while moving forward, it will reverse immediately.
-The brake works when you return to the neutral position.
[To use for robots and electronic work]
-MD-1 can be used for brush motors of type 370 and below.
-Since MD-1 does not have a power supply circuit like general ESC, [No.26014 Switch Harness BEC (for MD-1)] or [No.26002 Switch Harness BEC] [No.26012 Power Supply Unit NEW Connector ]please use.
[Can also be used for LED and buzzer control]
-MD-1 can also be used as a driver for LEDs and buzzers.
-Wiring can be changed by removing the protective transparent tube of MD-1.
-It is a large pattern so that it can be easily done when wiring with a soldering iron, but if you are not confident, please do wiring work under the supervision of someone with experience in electronic work.
[spec]
-Brush motor dedicated speed controller
-Size / 27.0 × 20.5 × 4.4mm
-Weight / 3.0g (body only)
-Compatible motors / DC motors for small models of 370 or less (motors with brushes with a lock current of 4 A or less)
-Supported devices / LEDs and electronic buzzers with current limiting resistors (Piezoelectric buzzers and speakers cannot be used)
-Control method / PWM control
-Appropriate power supply voltage / 3.0v to 6.6v (2 to 4 dry cells, NICD & NIMH 3 to 5 cells, LiFe 1 to 2 cells, LiPO 1 cell)
-Drive frequency / about 4KHz
-BEC output / None
( This is a machine translation. Please allow for possible misinterpretations in the text. )