Arched Flat File 5mm Single Cut (Hobby Tool) - HobbySearch Hobby Tool Store

This item is limited to 10 per household.

――It is arched and hard to bend! Hard to damage the side of the reverse edge!
――Because it is arched, it is hard to increase in strength! More accurate surface facing is possible!
-The arch part does not have a file, so it is hard to damage the side of the opposite edge!
-Kiwa's savior of parts that can be filed on the opposite edge to the last minute!

-[Kamaboko type] metal file. At first glance, it looks like a [Koumaru file], but there are no files on the instep, and it is actually a [flat file].
――Since there is no file on the arch part and the arch surface is narrower than the file surface, you can file to the last minute without damaging the side of the opposite edge.
――However, the reverse edge angle that can be scraped without damaging the side surface is in the range of 180 to 90 degrees.

--Width: Approximately 5mm
--Overall length: Approximately 100mm
--Pattern length: Approximately 50mm
--Weight: Approximately 12g
--File side: Single (fine)

Item Size/Weight : 19.5 x 6.5 x 1.2 cm / 26g