- This is an acrylic mold that allows you to make your own realistic bricks and pavements equivalent to 1/35, 1/32, and 1/48.
- It is possible to produce high-quality diorama accessories by reproducing various surface textures and patterns that reproduce real bricks.
- The best material to fill the mold is synthetic resin paper clay that hardens when air-dried, such as modeling clay DAS.
- Scale: 1/35 (1/48 - 1/32)
- Brick size: 2.8×5.7mm
- Brick thickness: up to 3mm
- Mold size: 6 x 11cm
- 75 pieces, 2 pieces, plastic spatula included
[how to use]
・1. Remove dirt and dust from the mold.
・2. Paste parchment paper, wet kitchen paper, masking tape, [GSWD-10354] Painting Equipment S (A6) size Mylar stencil sheet, etc. on one side of the mold.
・3. Place the mold on a flat surface with the sheet pasted side facing down.
・4. Fill with paper clay. Press the ball of clay into the mold with your fingers, making sure to fill it to the depths of the mold. You can adjust the thickness of the bricks by adjusting the amount of clay packed.
・5. Level the surface. Remove excess clay from the surface using the included plastic spatula.
・6. Let the clay dry until it hardens. Paper clay shrinks slightly when it dries.
・7. Once the clay has completely hardened, slowly and carefully peel off the sheet attached to the mold.
・8. Take out the brick. Gently poke the brick with the round tip of a brush handle and push it out of the mold.
・9. Smooth out sharp edges of bricks. A good idea is to place a brick on your palm, hold it with both hands, and shake it gently.
・10. Use bricks. It can be used for road paving, wall decoration, etc. Use instant adhesive or an acrylic sealer such as [GSWD-4149] Medium Decoupage Matte (matte) for bonding.
( This is a machine translation. Please allow for possible misinterpretations in the text. )