This item is limited to 5 per household.
- Extreme popularity product [minus Mold & pile] reproduction.
Basic metal items precise detail up.
- Metal parts basic article of cutting [minus mold] [minus pile].
Review the content and the amount of quantity and add 0.7mm.
- To rivet detail newbuildings minus bolt and wind replacement of existing parts parts thing sawing metal.
- The detail up negative bolt shape which gave the design to the new character models
Is a part. Ease of use can not be obtained by the diversion and precision screw, an angle was considered is a characteristic.
Because it is a part of the rivet type with a pin on the lower surface, even after coating the part to be attached, and on which
It can be installed by cover from.
- It's easy to use. You can open a big hole than 0.1mm hole of the same diameter as that of foot parts you want to install, and diluted
OK if you bonded with low whitening instant adhesive very small amount and clear bond. And metal primer,
You can also use the model for normal paint if you paint the surfacer.
- If you divert the precision screws, burr or remain in the pickpocket absolutely, cutting surface or are rough
And then, but there is no such a thing in this product. Polite post-processing to be used without paint
I'm going to. Please check the quality of specialized products only.
- The combination of the metal ring (sold separately), you can make a small Maruichi parts.
It is recommended to detail up of moving parts and joints.
- The height of the head may vary depending on the diameter, please select it by referring to the image. Diameter is greater
I will be about flat. You have been provided a metal ring that corresponds to 1.0mm ~ 3.0mm is (not included)
( This is a machine translation. Please allow for possible misinterpretations in the text. )