── new series of professional preference [Kiwaza] Kirewaza!
The first installment is tungsten carbide tools for carving streaks
- It is a precision tool that has been developed for the streaks carving.
- It has achieved a sharpness and high durability of surprise in that you use the very hard cemented carbide (tungsten carbide).
- Cutting edge is worked flat sword type of edge, you can perform a streak carving of uniform width.
- It does not change the thickness of the line also with deep carving.
- Cutting edge is possible streaks carved from the corner like a so acute angle Figure (1).
- The width of the blade five (0.1 · 0.15 · 0.2 · 0.25 · 0.3mm). Mounting a ring that is color-coded for each size.
- Use by attaching to Kiwaza holder or a pin vise and the like.
[how to use]
- Kiwaza until the holder or φ3.2mm will be used in wearable pin vise or the like.
- Do the stripes carved by pulling in front as in the figure (2).
- Please pull straight so as not to lean to the left or right.
- It is beautiful to finish trick is overlaid on without putting the force carved many times.
- Please note that the rough and machined surface to focus.
[Precautions]
- Material of the streak-carved carbide is very hard cemented carbide.
- Because there is no stickiness instead hardness is high, twist, play or, it may break when a force from the side is it takes.
- Please especially careful when using the thin streaks carving car bytes of streaks carving and 0.1 ~ 0.2mm of the curve.
( This is a machine translation. Please allow for possible misinterpretations in the text. )