Product Description

- [Kiwaza Series] 4th! A new size in streaks carving carbide (0.6mm, 0.8mm, 1.0mm, 1.2mm) add

- it is a precision tool that has been developed for the streaks carving.
- it has achieved a sharpness and high durability of surprise in that you use the very hard cemented carbide (tungsten carbide).
- the cutting edge in the worked flat sword type of edge, you can perform a streak carving of uniform width. And deep carving does not change the thickness of the even line.
- the cutting edge is possible streaks carved from the corner as of so acute angle Figure (1).
- the width of the blade is five. Wearing the ring that was color-coded for each size.
- Use by attaching to Kiwaza holder or pin vise or the like.

[how to use]
- Kiwaza until the holder or φ3.2mm will be used in wearable pin vise or the like.
- do the streaks carved by pulling in front as in the figure (2).
- Please pull straight so as not to tilt to the left and right.
- it is beautiful to finish trick is superposed on without a force carved a number of times.
- Please note that rough and machined surface to focus.

[※ Precautions]
- Material of the streaks carved carbide is very hard cemented carbide.
- because there is no stickiness instead hardness is high, twist, play or, it may break when a force from the side is it takes.
- Please especially careful when using the thin streaks carving car bytes of streaks carving and 0.1 ~ 0.2mm of the curve.



Item Size/Weight : 9.5 x 6 x 2 cm / 10g

Product Specifications

Item series

Kirewaza

Item code

SB-10

JAN code

4580488730966

Purchase Information