- Train and Graffiti 's Train is not about a train, it says that `scribbles drawn on a train` is a train (Train) or train bomb (TreinBomb).
- Graffiti (Graffiti) also scribbles drawn with spray or felt pen.
- Because of intense self-assertion Because colorful graffiti is usually drawn by choosing a place that is visible to human eyes, it is often seen in sunny places and many busy walls and buildings. So when reproducing with a diorama it is good to pay attention to that point.
- Corresponding scale: 28 mm, 32 mm, 54 mm (1/58, 1/54, 1/32)
- Number of packing: 2 sheets
- Size: 148 × 210 mm (A5)
* It is a criminal act to be asked about damage of a car when actually doing graffiti in the public.
- Slide decal sheet set This set consists of two sets of slide decals with high-precision printing and with hardly water-resistant lily.
- Because this decal can be stuck with water-based glue, it does not need solvent.
- Also additives for decal form, such as decal softer and decal fixer prepared by GSW, can make it adhere to roughened surface with roughness and improve surface protection.
- Each slide decal sheet includes more versatile graffiti and more unique and creative finish can be obtained by pasting these decals on the battlefield or building's dioramas.
[Basic task of sticking decals]
- Cut out the edge of the decal you want to paste as closely as possible.
- It is a good idea to prepare a new product that cuts such as cutters are well cut so that the cut surface will be finished cleanly.
- We pick up the decal cut out with tweezers for each mount and soak it in water for about 20 seconds.
- If you use lukewarm water at this time it will melt better and the film will soften as well.
- When the lifted decar moves from the mount, put it on the surface of the target model you want to paste along with the mount and move it to the place where you want to gently place the decal with a brush etc.
[To those who aim for more sophisticated work]
- When deciding where to place the decal on the model, apply the GSW decal fixer to the surface.
- This fixer can smoothen the surface to protect the coating painted on the model and prevent the decal from lifting like Silverring.
- Move the decal brought together with the fixer on the surface to which the fixer was applied with a brush etc.
- When the decal moves hard from the mount at this time, add a little moisture or fixer and move the decal so that it floats up to the place where it was affixed.
- There is a possibility that wrinkles will occur in the decal itself when the part to be decaled is curved like a fender.
- If you attach a decal to suppress this, use GSW decal softer.
- Softener contained in the softer will respond to the form and will become familiar with the curved surface like fender Please remove wrinkles.
- Use a cotton swab to remove moisture and additives that accumulated between the decal and the model surface.
- Cotton swab rolls the surface of the decal and please push the moisture between the decals.
- At this time it would be better to roll the cotton swab in a radial pattern to extend the wrinkles on the curved surface.
- Also laying paper towels and rolling paper rolls from above will make the decals closely adhere and moisture will be removed.
- When using GSW decal softer it is unnecessary to cut the wrinkle on the decal.
- Finally, apply GSW decal fixer to unify the decal and the luster of the surface of the model.
- If finishing work of shiny on it is necessary, paint clear paint for glossy or glossy model after drying well.
( This is a machine translation. Please allow for possible misinterpretations in the text. )