Product Description
-Air tank made of reinforced plastic without worrying about rusting!
-A set of an air tank pot and a dedicated rack that can be attached to an air compressor to store air.
-By storing air once in the air tank, it is possible to supply air that suppresses the pulsation (pulse) that occurs during compression.
-The air tank body is made of reinforced plastic, eliminating rust that was a problem with conventional steel air tanks. It is a specification that is less susceptible to damage and failure due to rust.
-Air tank capacity is about 0.7L, which is enough for model production and painting.
-A regulator with a pressure gauge with a built-in air filter is set on the air outlet side.
-Rotate the outlet joint of the regulator and adjust the direction of the air hose for easy painting.
-Lightweight and compact size that can be placed on the workbench.
-Comes with 2 small airbrush hangers attached to the support rack and 1 short type spiral air hose.
* This product does not amplify the compressor pressure. Even if it is combined with a small compressor such as our compressor 058 or a compressor with a weak pressure, it may not be able to realize a sufficient effect.
[please note]
・ The working pressure of this product is up to 0.4MPa. Make sure that the air pressure from the compressor does not exceed 0.4 MPa.
・ If the compressor does not have an automatic pressure switch, or if the compressor cannot be used in combination with an air brush with an air valve, the switch may need to be turned on and off by itself during operation.
-Recommended compressor: equipped with automatic pressure switch
-Product size:
・ Body diameter: Approximately 110mm
・ Body width: Approximately 215mm
-Body height: about 180mm (on the regulator: about 237mm)
-Support rack size (width x height x depth): approx. 215 x 71 x 130mm
-Tank capacity: 0.7L * Reference value
-Maximum working pressure: 0.4 MPa or less * The working pressure of this product is up to 0.4 MPa. Make sure that the air pressure from the compressor does not exceed 0.4 MPa.
-Air inlet / outlet joint: S thread (1/8 type)
-Set contents: Air tank pot body (with regulator), dedicated support rack, spiral air hose (effective extension: approx. 1mm), simple airbrush hanger x 2 (with screws)
* Images are for development and may differ from actual products.
( This is a machine translation. Please allow for possible misinterpretations in the text. )
Item Size/Weight : 27 x 27 x 26.5 cm / 2720g
Product Specifications
- Item code
- LT-036
- JAN code
- 4943209430369
Purchase Information
This item is limited to 2 per household.