Product Description

- Balsas Stripper

- Designed to cut materials such as balsa sheets, styrofoam sheets, plastic boards, cork boards, etc.
- Maximum thickness is 6mm, width can be cut from 1mm to 25mm.

- There are two positions to place the blade, one for left-handed and one for right-handed.
- When positioning the blade, make sure the tip of the blade is flush with the hobby cutting mat you are working on.
- If it's too high, the cut will be incomplete.

- When folding hard plastic sheets, bend them with your hands only enough to avoid injury.

- Here's a general guide on how to use it:
1. Fix the material: Place the item you want to cut on a flat, stable surface. If necessary, use clamps or double-sided tape to fix it in place.
2: Setting the desired width: Adjust the guide to the desired width. To do so, simply move the blade to the raised millimeter and inch marks and tighten the locking screw. This allows you to accurately determine the thickness of your board. Then position your material with the blade aligned over the starting point of the cut. Make sure the orientation is correct based on the desired strip length.
3: With the material firmly in place, pull the tool towards you along the long support line, applying gentle, consistent pressure. The blade slices through the material, creating a board of consistent width determined by the previously set cutting width. A screw mechanism ensures the blade maintains the set width throughout the cut.
4. Repeat the process: If multiple boards of the same width are required, reposition the stripper and repeat the process.

- Pack of 10 replacement blades
*Please remove the blade after use and store it away.



Item Size/Weight : 16.7 x 10.6 x 5.5 cm / 95g

Product Specifications

Item code

GSWD-3113

JAN code

8435646504735

Purchase Information