Product Description

- It is a precision tool developed for streak carving.
- By using very hard cemented carbide (tungsten carbide), surprising sharpness and high durability are realized.
- The cutting edge is a flat sword type with an edge effect, it can do streak carving of uniform width. Even if deep engraving, the thickness of the wire does not change.
- Since the cutting edge is sharp, it is possible to carve streaks from the corner as shown in Fig. (1).
- 5 types of blade width. A color-coded ring is attached for each size.
- Attach it to a slaughter holder or pin vise and use it.

[how to use]
- Use it with an armor holder or pin vise etc. that can be mounted up to φ 3.2 mm.
- Pull it toward you as shown in figure (2) and do streak carving.
- Please pull straight so that it does not tilt to the side.
- It is a trick to finish carving and stacking repeatedly without putting strength.
- Please be careful as machining surface becomes roughened by putting force.

[※ Note on use]
- Streak carving Carbite material is very hard cemented carbide.
- Because there is no stickiness instead of high hardness, there are times when it twists, it plays, it is broken when it receives force from the side.
- Be especially careful when using the curve streak carving and thin streak carving carving of 0.1 - 0.2 mm.



Item Size/Weight : 9.5 x 5.8 x 2.2 cm / 11g

Product Specifications

Item series

Kirewaza

Item code

SB-15

JAN code

4580488730683

Purchase Information