Product Description

-A set that reproduces a light bulb lamp with a shade suspended from the factory ceiling.
-The lamp shade, the base on the ceiling side, and the switchboard are made of gray resin, and the light bulb is reproduced with transparent resin.
-Copper wire for wiring and metal chain for hanging are attached.
-The height of the metal chain connecting the ceiling base and the bulb lamp can be adjusted at the position where both ends are connected.
-Set contents: 1 set Suspend type light bulb lamp 2 pieces, high quality resin, transparent resin, 1 copper wire, 1 length 10 cm metal chain, number of parts: 9 points

[Tips for street light production]
-Please cut out the street light frame part because the inside of the frame is buried like a burr for convenience of molding.
-Make a hole in the inner four corners of the frame with a pin vise.
-If you use a large diameter drill, the frame may be damaged, so use a 1 mm diameter drill as a guide.
-Cut out unnecessary parts in the frame like widening the opened hole with a sharp cutting knife.
-Shape the cross section with a precision metal file or waterproof paper.
-Please stick the double-sided tape on the enclosed glass template (copyable), we recommend the double-sided tape that can be stuck and peeled off.
-Stick the taped template on the included transparent plastic board.
-If you polish the transparent plastic board with a compound etc. before pasting, it will have a more glass-like finish.
-It is a good idea to band the transparent plastic plate along the template so that unnecessary parts are as small as possible.
-Please cut out the transparent plastic plate in the way that you push it with a working knife that cuts well according to the template you stuck.
-Cut each side rather than cut out, the cross section will be cleaner and the shape will be cut accurately.
-Cut out 4 pieces of this for each street light.
-Peel off the template paper from the cut out transparent plastic plate and glue it inside the streetlight.
-Since the street light of this product has a gap between the inside of the frame and the glass, it is better to glue the plastic plate in a square shape first and then to put it inside the street light.
-For bonding, it is recommended to use instant adhesive, transparent rubber bond, model adhesive, etc. where necessary.

Product Specifications

Item series

Accessory Parts

Item code

MAC35189

JAN code

4573105665727

Purchase Information