Product Description

──Recommended for beginners of streak carving car bytes!

--A precision tool developed for streak carving.
――By using a very hard cemented carbide (tungsten carbide), surprising sharpness and high durability have been achieved.
――The cutting edge is a flat sword type with an edge, and you can carve streaks of uniform width.
――The line thickness does not change even if you carve deeply.
――Since the cutting edge has an acute angle, it is possible to carve streaks from the corner as shown in Fig. (1).
Attached.
--Use by attaching to a slashing holder or pin vise.

[set content]
・ Streak carving car bite 0.15 × 1
・ Slashing holder slim x 1
・ Streak carving car bite protection case x 1
・ Polishing / fluff removal brush x 1

[how to use]
--Use with a slashing holder or a pin vise that can be attached up to φ3.2 mm.
--As shown in Fig. (2), pull it toward you to carve a streak.
――Pull it straight so that it does not tilt to the left or right.
――The key to a beautiful finish is to carve it over and over again without exerting any force.
――Please note that the machined surface will be roughened if force is applied.

[Precautions for use]
――The material of the streak carving carbide is a very hard cemented carbide.
――Although it has high hardness, it is not sticky, so it may break if it is twisted, flipped, or subjected to lateral force.
――Be especially careful when using curved streaks or thin streak carvings of 0.1 to 0.2 mm.


Item Size/Weight : 12.8 x 7.5 x 1.5 cm / 64g

Product Specifications

Item series

Kirewaza

Item code

SB-015SLIM

JAN code

4580488731031

Purchase Information