-A product equipped with a room light (very large reduction of flicker) function that can store electricity with great popularity since it was released last year
-A type A (popon detta, TOMIX product narrow type support)] is newly released.
-Equipped with 15 LEDs
-Compatible with TOMIX and Micro Ace vehicles, but some vehicles can not be mounted.
-It can not be installed in the case of a tram or vehicle-only room light
[how to use]
-Attach the attached spring to the board and attach it to the vehicle body.
-Attach the supplied adapter to the part that strikes the vehicle body support opposite to the spring.
-Cut the LED board according to the length of the vehicle where it can be cut.
※ The adapter will only be used in vehicles other than pop-up detta.
[About the switch]
-The light source strength can be switched with a switch on the board
-Mode S: This is a normal mode considering the illuminance of the actual vehicle. Because the amount of stored electricity is large, the flicker reduction effect is large.
-Mode H: High illumination mode with brightness priority. Because the storage amount is small, the flicker reduction effect is small.
※ The initial setting is mode S setting.
[Note]
-Please use this product at 12 V or less.
-Some functions may not be available depending on the operating environment.
-As it is a room light for N gauge, usage other than this application is strictly prohibited.
[set content]
・ One board
・ 2 current collecting springs
・ One adapter
※ Specifications are as of the end of February 2019. There is also a case of specification change in commercialization.
( This is a machine translation. Please allow for possible misinterpretations in the text. )