Product Description

-Masking sheet for digital camouflage (pixel camouflage) & honeycomb (regular hexagon) according to 1/144 size

-You can design fine and complex patterns easily by combining each piece without the hassle of cutting.
-Be sure to use tweezers to remove the seal from the sheet.
-It is recommended to use a wide surface in combination with normal masking tape.
-When camouflaging a large area, digitally camouflage the piece at 45 degrees for better appearance.
-It is so fine that it has low adhesion and cannot be used repeatedly.
-Use a cotton swab, etc., to tightly adhere the part where the seal is stuck. (May shift from diagonally above.)
-After painting, dry completely and it will come off from the coating.
-When removing the mask, gently peel off the side with the tip of a design knife or a needle and peel it off with tweezers.
-If it is difficult to peel off the backing paper, peel off the excess part first (screw up).
-Please press down the whole body slowly and carefully before scraping.
-Please note that when scraps are raised, all the pieces are completely cut, but the pieces are finely attached to the extra parts about 10%.
-There is a small size difference for each piece in mass production process.

[size]
-Seat: about 21 × 10cm
-Dots: Approximately 1mm to approximately 0.9mm and approximately 0.5mm to approximately 0.4mm 2 types
-Honeycomb: 2.5mm width and 1.7mm width 2 types


Item Size/Weight : 24 x 15.3 x 0.1 cm / 9g

Product Specifications

Item series

Mask

Item code

756901

JAN code

4582119756901

Purchase Information