Product Description
--Transporting 800 million tons! Chikuho's two-axle coal car!
[Actual vehicle introduction]
Fukuoka Prefecture is home to numerous coal mines, including those in Iizuka, Nogata, Tagawa, Omuta, and Arao, and large amounts of coal were extracted there from the Meiji period until after the war.
This coal was transported by rail to major ports such as Kanda and Kitakyushu, and then shipped to various parts of Japan.
These coal freight trains were operated using small two-axle freight cars with inverted trapezoidal hoppers, and long trains of 20 or 30 cars could be seen being pulled by steam locomotives such as the 9600 or D50.
The SEM 6000 is a 15-ton coal car manufactured from 1939 onwards as a quasi-wartime design that was lighter than conventional vehicles.
However, there were shortcomings in the strength of the underframe, and after the structurally reinforced SEM 8000 was produced, the Sera 1 was produced in 1957, with a load capacity increased to 17 tons.
At its peak, there were over 4,000 Sera 1 cars in service, including those converted from SEM 6000 and SEM 8000.
The Sef 1 is a vehicle based on the Sem 6000, with one-quarter of the body converted into a conductor's compartment.
Kyushu coal, which supported Japan's modern development, began to decline around the 1960s due to a decrease in mining volume, the influx of coal from overseas, and the shift to oil as an energy source.
All SEM 6000s were scrapped in 1979, all Sera 1s in 1986, and all SEF 1s in 1985.
[Organization diagram]
Sera 1047 +
Sera 5364 +
Sera 1580 +
Sera 796 +
Sera 5051 +
Sef 223*Power is not included
*A separate powered vehicle is required for operation.
*The Sef223 taillights do not light up.
*Sera 6211 is a [type] model made using the Hora 1 mold.
*Some parts may differ from the actual vehicle due to shared parts.
[Product overview]
Further enhancement of the Micro Ace freight car series
Sera 1, Sef 1, and Sem 6000, which created an era of JNR coal cars, are now available as products without the yellow stripe as they were before October 1968.
A3004 is a set of 5 intermediate cars Sera1 and 1 conductor's van Sef1.
A3005 is an all-intermediate car. In addition to five Sera 1s, one low-height Sem 6000 is included.
*SEM 6000 is a [Type] model that reproduces only the markings using the mold of Hora 1.
Parts are pre-installed to recreate the state of a loaded coal car. These can also be removed to recreate the empty car.
A3004 and A3005 can be combined to reproduce any long train formation.
[accessories]
none
( This is a machine translation. Please allow for possible misinterpretations in the text. )
Item Size/Weight : 19.4 x 11.8 x 3.4 cm / 176g
Product Specifications
- Item code
- A3004
- JAN code
- 4968279804636
Purchase Information
This item is limited to 24 per household.