This item is limited to 20 per household.
[Sensor unit (vehicle track circuit equation)]
- A kit for the track circuit corresponding to the formula, the kit made by automatic crossing MES.
※ This kit alone it can not be used.
※ Please use in conjunction with the corresponding MES kit.
[Product support]
-
automatic crossing Kit (for N gauge)-
automatic crossing Kit (for HO gauge)[Content of set]
- Cable for (1): 1m × 2
- Dedicated printed circuit board (2): one
(3) - Photocoupler pcs: 4 TLP-521-2 ×
Resistance - (4) × 2 1KΩ ×
(5) - Diodes: 1N4007 × 8 pieces
- Assembly instructions vehicle sensor unit
[Connection with sensor]
- The wiring as shown in the figure from (J1/J4) RAIL terminal of this unit.
- I like to wire the unit sandwiched between the rail and the wiring between the power pack.
- The boundary between the zone you want to detect is to put insulation gap on one side of the rail.
- Do you want to connect to another sensor input to other sections of this unit, I will do the wiring of the power pack.
- Because there is a potential difference between the section and not put the sensor, do you put the sensors of the machine in the sky,
I recommend that you put a diode aligned potential difference.
※ combination with low voltage such as a battery-powered power pack is not suitable.
[Notices]
- Because I can make a printed circuit board only, without having read a circuit diagram! (
more information )
Okay - even for beginners! Illustrated with manual soldering! (
more information )
( This is a machine translation. Please allow for possible misinterpretations in the text. )