This item is limited to 20 per household.
[Unit double track automatic crossing]
- A kit for making multi-line corresponding to the formula, the automatic crossing kit, a kit made by automatic crossing MES.
※ This kit alone it can not be used.
※ Please use in conjunction with the corresponding MES kit.
[Product support]
-
automatic crossing Kit (for N gauge)-
automatic crossing Kit (for HO gauge)[Content of set]
- Dedicated printed circuit board (1): one
- (2) IC: Each 1 MK-N02-P1 ×
- (3) IC socket pcs: 1 8Pin ×
- Terminal regulator (4) 3 pcs: 1 78L05 ×
- (5) ceramic capacitor pcs: 2 1μF ×
- Electrolytic capacitors (6) × 1 22 ~ 47μF ×
Resistance - (7) × 2 10KΩ ×
- Cable for (8): 1m × 2
[Assembly of wiring]
- I used (kit for) and the target kit this kit. Should be connected as follows.
- Please use the same power supply of a kit of two.
Each line is connected to each of the upper and lower sensors with reference to FIG.
Make sure that the assembly of the kit instructions as target specific connection method.
- Please connect in the same way as the single-wire each sensor.
SENSOR2 can be the reverse and SENSOR1.
- The power supply should be connected to each other and GND VSS of each substrate.
- START signal connections should be connected to each line in the same direction as shown in the diagram on the left.
- 3-wire, add this kit as necessary in the case of quadruple track.
I connected in parallel to the power supply and wiring of S1.
You can also not only this kit (and add the target kit.
In this case, each alarm will be linked)
[Notices]
- Because I can make a printed circuit board only, without having read a circuit diagram! (
more information )
Okay - even for beginners! Illustrated with manual soldering! (
more information )
( This is a machine translation. Please allow for possible misinterpretations in the text. )